Stored Procedures - Do you use error handling in your Stored Procedures?

Last updated by Brook Jeynes [SSW] 11 months ago.See history

You should always include error handling in your stored procedures, it allows you to catch errors and either log them or attempt to correct them. THROW (Transact-SQL) lets you generate your own custom error messages, which can be more detailed in describing the problem and assist in debugging.

Here’s an example of the syntax used when implementing THROW.

-- Syntax
THROW error_number, message, state;

Figure: Example of the THROW syntax

There are 3 main arguments:

  • error_number (int) - Must be greater than or equal to 50000 and less than or equal to 2147483647.
  • message (nvarchar) - Maximum of 2048 characters.
  • state (tinyint) - Must be between 0 and 255

The state argument can be used to help pinpoint where the error occurred by using a different value without changing the error_number or message . This is useful if you have multiple steps in a process that may throw identical error descriptions.

-- Example
THROW 51000, 'The record does not exist.', 1;

Figure: Example of using THROW

Implementing Error Handling using THROW

Here we are generating a divide-by-zero error to easily raise a SQL exception and is used as a place holder for logic that we would have in our stored procedure.

DECLARE @inputNumber AS INT = 0;
-- Generate a divide-by-zero error
SELECT 1 / @inputNumber AS Error;

Figure: Bad Example - No error handling.

Below we have wrapped our stored procedure logic in a TRY block and added a CATCH block to handle the error. More information can be found here TRY...CATCH (Transact-SQL).

We know this divide-by-zero is going to cause an exception and the error number for this specific SQL exception is 8134. See (MSSQL Errors) for more error numbers.

In our CATCH block, we check the error to ensure it’s the one that we want to handle otherwise, we re-throw the original exception. Finally, when we catch the error we are looking for we can log some information about it and attempt to run our stored procedure logic again with different parameters.

DECLARE @errorCode AS INT;
DECLARE @inputNumber AS INT;
       -- Generate a divide-by-zero error
       SET @inputNumber = 0;
       SELECT 1 / @inputNumber AS Error;
       SET @errorCode = (SELECT ERROR_NUMBER());
       IF @errorCode = 8134 -- Divide by zero error encountered.
                    PRINT 'Divide by zero error encountered. Attempting to correct'
                     SET @inputNumber = 1;
                    SELECT 1 / @inputNumber AS Error;

Figure: Good Example - Using error handling to catch an error and attempt to resolve it.

The example below shows how you can catch an error and retrieve all the details about it. This is very useful if you want to save these errors to another table or trigger a stored procedure.

       -- Generate a divide-by-zero error. 
       SELECT 1 / 0 AS Error;
             ERROR_NUMBER() AS ErrorNumber,
             ERROR_STATE() AS ErrorState,
             ERROR_SEVERITY() AS ErrorSeverity,
             ERROR_PROCEDURE() AS ErrorProcedure,
             ERROR_LINE() AS ErrorLine,
             ERROR_MESSAGE() AS ErrorMessage;
		             -- Insert logic for persisting log information (Log to table or log to file)

Figure: Good Example - Using error handling to catch an error and retrieving its details, allowing it to be logged.

Christian Morford-Waite
We open source. Powered by GitHub